aireRyder FN66635 설치 및 사용 설명서 지침 - 페이지 4

{카테고리_이름} aireRyder FN66635에 대한 설치 및 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. aireRyder FN66635 8 페이지. Ceiling fan model borealis

Fig.9

1. Make house wire connections. Follow diagram on the right and make sure that all exposed wires are

tightened by screw on terminal block.

Note:

a.) The terminal block shown in right graph is pre-installed on the mounting bracket.

b.) After wiring is completed, gently push wires into hanger bracket with terminal block facing upward (if applicable).

2. a.) Slide receiver through hanger bracket as shown.

b.) Plug the male connection of receiver wires into the female connector of motor wires.

c.) Insert the infra-red sensor into the hole on the canopy

d.) Make fixture wire connection. Plug the male connector into female connector.

(Do not force it into wrong receptacle as it will cause damage.)

Fig.10

Hanger Bracket

Canopy

Key Hole

Slot

Canopy Screw

Remove one canopy screw (for

later use), then push the canopy

upwards by inserting canopy screw

head left in hanger bracket into key

hole slot, rotate the canopy till the

hole in canopy aligns the hole in

hanger bracket, finally, secure the

canopy to hanger bracket with

previous canopy screw and tighten

the other canopy screw.

Attach the decorative cap to

canopy,rotate it clockwise until tight.

171213

Canopy Screw

Decorative Cap

Remove the glass holder plate from

motor by removing three set screws.

Fig.11

Moto r

Glass Holder

Plate

Set Screw