Gamber Johnson 7160-0318-07 설치 지침 매뉴얼 - 페이지 3
{카테고리_이름} Gamber Johnson 7160-0318-07에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamber Johnson 7160-0318-07 10 페이지. Panasonic toughbook cf-31 docking station
페이지 인쇄
IMPORTANT SAFETY INFORMATION FOR
Safety is dependent on the proper installation and servicing of this docking station. It is important to
read and follow all instructions before installing this product.
To properly install Gamber Johnson docking station you must have a good understanding of
automotive electrical procedures and systems, along with proficiency in the installation and service of
aftermarket vehicle equipment.
There are no adjustments required at any time of the electrical components within the docking station.
Opening the port replication housing will void the product warranty.
During Installation:
•
DO NOT connect this docking station to the vehicle battery until:
1.
ALL other electrical connections are made
2.
Mounting of ALL components is complete
3.
VERIFICATION that no shorts exist in the entire system
•
DO NOT install equipment or route wiring or cords in the deployment path of any airbag.
•
When drilling into the vehicle. DO make sure that both sides of the surface are clear of anything
that could be damaged.
CAUTION: If wiring is shorted to the frame, high current conductors can cause hazardous
sparks resulting in electrical fires or flying molten metal.
After Installation:
•
Test the docking station to ensure that it is working properly.
•
File these instructions in a safe place and refer to them when performing maintenance or re-
installing.
WARNING: Failure to follow all safety precautions and instructions may result in property
damage, serious injury or death.
PRE-INSTALLATION RECOMMENDATIONS
Conduct a "Bench Test"
Gamber Johnson strongly advises a "Bench Test" be conducted to verify that all electronic and software
issues are resolved prior to installation:
1.
Make sure computer is operational by itself.
2.
Insert computer into docking station and verify that the computer is operating in the dock.
3.
Interconnect entire assembly and verify start-up of all components, including other equipment
(printers,modems, scanners, etc.)
*Gamber Johnson recommends positioning of all mounts and equipment in the vehicle prior to the actual
install to verify that mounting locations are safe and practical.
INSTALLERS
Pg 3