Gree Multi21 CONS12HP230V1AF 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Gree Multi21 CONS12HP230V1AF에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gree Multi21 CONS12HP230V1AF 18 페이지.

페이지 인쇄

OPERATION OF REMOTE CONTROLLER (Continued)

NOTE

• Under status, you can set T-OFF or T-ON simultane-

ously.

• Before setting T-ON or T-OFF, please set the clock.

• After starting T-ON or T-OFF, set to "circulating"

mode.

• Your unit will be turned on or turned off according

to setting. ON/OFF button has no effect on setting.

If you don' t need this function, please use remote

controller to cancel it.

Press this button to start I FEEL function and " " will be

displayed on the remote controller. When set, the remote

controller will send the detected ambient temperature

to the controller and the unit will automatically adjust

the indoor temperature according to the detected

temperature. Press this button again to cancel I FEEL

function and " " will disappear.

• Put the remote controller near the user when this

function is set. Avoid putting the remote controller

near an object of high or low temperature. When

I FEEL function is turned on, the remote controller

should be put where the indoor unit can receive the

signal sent by the remote controller.

Press this button to set clock time. " " icon on remote

controller will blink. Press " " or " " button within 5s

to set clock time. Pressing the " " or " " button, clock

time will increase or decrease 1 min. If you hold " " or "

" button for longer than 2s the time will change rapidly.

Release this button when reaching your required time.

Press "CLOCK" button to confirm the time. " " icon

stops blinking.

NOTE

• This is a 24 hour clock.

• A delay of more than 5s in setting the ON and OFF

times will cancel the set-up and you will have to

start over. Operation for TIMER ON/TIMER OFF is

the same.

Under COOL or HEAT mode, press this button to start

up sleep function. " " icon is displayed on remote

controller. Press this button again to cancel sleep

function and " " icon will disappear.

MIN I- F LOO R CO N SO L E A S E R I ES OWN E RS M A N UA L - I N D OOR UN I T

NOTE

• During this procedure, if no button is pressed within

10 seconds, remote controller will automatically exit

the sleep curve setting and resume original display.

If ON/OFF, SLEEP, COOLING or HEATING button

is pressed during the setting or inquiry procedure,

remote controller will also exit the sleep curve

setting.

Press this button to turn off display light on indoor unit.

" " icon on remote controller disappears.

Press this button again to turn on display light. " " icon

is displayed.

Press this button to see the indoor set temperature on

the unit's display. The setting on remote controller is

selected circularly as below:

| 1 2