AGT INDUSTRIAL AGT-B1000 제품 설명서 - 페이지 9

{카테고리_이름} AGT INDUSTRIAL AGT-B1000에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AGT INDUSTRIAL AGT-B1000 19 페이지. Two-post auto lift

3 - Check Before Start

1. Check anchor bolts, nuts, fittings and etc have been installed properly.

2 . Check if all moving parts move freely.

3 . Make sure inside of the columns is clean and no other objects.

4 . Supply grease between slide blocks and columns, cables and pulleys.

5 . Check if the arm lock is locked while raising processing, and adjust lock if necessary.

Note: Loose the screw to adjust when necessary( Fig 10 ).

Make sure all wiring are same as below circuit diagram ( Fig 1 1 ) .

Attention:

electrical system connection must be done by licensed electrician .

Warning

When installing the power cord for the first time, remove the test cable( short wire)

from the motor and replace it with a cable(wire)

between motor starts is at least more than 2 seconds. Otherwise the motor or AC contactor

may be burnt out.

suggest to use min 3 0 A breaker ( not higher than the wire load) .

Fig 9 Arm Installation Diagram

Fig 10 Pulling Rod Installation Diagram

Page 9 of 19

less than # 12 gauge. The time interval