Gree Terra GWH18TC-D3DNA1A 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Gree Terra GWH18TC-D3DNA1A에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gree Terra GWH18TC-D3DNA1A 2 페이지. Ductless heat pump

KEY FEATURES & FUNCTIONS

QUIET MODE

Unit operates normally for ten minutes, then shifts to Low fan speed for soothing, quiet comfort.

ENERGY SAVING MODE

Automatically selects optimal fan speed to save energy in COOL and HEAT modes. Press TEMP and CLOCK simultaneously to activate.

TIME GUARD

This prevents rapid cycling of the compressor to protect the unit from damage.

INTELLIGENT DEFROST

This increases room comfort and saves energy by sensing the need for defrosting and eliminating unnecessary defrost cycles.

POWER FAILURE MODE

Your settings and parameters are stored in non-volatile memory and are retained during a power failure.

I FEEL

This function senses the temperature at the remote controller instead of at the indoor unit. It then adjusts airflow and temperature accordingly

for the ultimate in personal comfort control and energy savings.

SLEEP MODE

You design a cycle to automatically adjust room temperatures during your sleep time, to maximize comfort and reduce utility bills.

COLD BLOW PROTECTION

In heating mode, the system delays fan activation until the coil has warmed up, to prevent blowing uncomfortable cool air into the room.

PHOTOCATALYTIC FILTER

Advanced technology to improve indoor air quality and prevent the spread of bacteria and viruses.

FAQs

Why does the fan continue to run even when the unit is not cooling or heating?

To maintain consistent temperatures and minimize energy-loss from constant starts and stops, the fan keeps air flowing past the thermostat.

What temperature is displayed on the remote controller?

The remote always displays your desired indoor temperature. (You may view current indoor and outdoor temperatures on the indoor unit's

Front Panel Display.)

What happens if the remote is lost or damaged?

Use the Manual Override button to manually operate the unit. Lift up the front panel section on the indoor unit and locate the button

on the right-hand side. Press the button to turn ON the unit. (Not all functions will be available.) Press again to cancel Manual Override Mode

and transfer control back to the remote controller.

Not all features available on all models. Your actual heat pump system and related devices may differ from the images shown in this manual

For complete instructions on these and other functions,

as well as important safety information, see the Owners Manual.

For more information, visit GreeComfort.com.

Specifications are subject to change without notice. Manufacturer reserves the right to discontinue, or change at any time,

66129913977