GAME 4514 소유자 매뉴얼 - 페이지 6

{카테고리_이름} GAME 4514에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GAME 4514 12 페이지.

페이지 인쇄

1. Parts List/Reference

INSTALLATION INSTRUCTIONS

Heater – Filter – Pool Layout

The system layouts below will help you install the solar heater(s) to your above ground pool.

BEFORE INSTALLING SOLAR HEATER

Heater - Pool Connections

These instructions assume that the pool and filter system are already assembled and there is a hose attached to the pool return (pool

water inlet). Place the heater in a location where it will receive the greatest amount of sunlight and at least 10 feet away from pool.

NOTE: Hose connectors may come preinstalled.

1) Heater - Filter Pump Connection

a) Turn off filter pump.

b) Block water flow at both the pool return inlet and the filter pump outlet

to prevent water from flowing through the hoses.

c) Detach the pool return hose from your filter system and set aside.

NOTE: If you are using an INTEX® filter, remove the

hose adapter from the filter port as well.

d) Locate outlet connector and attach to base using bracket & screws provided.

e). Locate the inlet connector and the long filter hose. Attach the long filter hose

between filter outlet (the port where the pool return hose was previously

connected) and the inlet connector (located at corner of heater) using the

included hose clamps (see figure 2).

NOTE: Depending on the size of your hose, the 1¼"-1½" reducer may need to

be used. Insert the reducer inside of the long filter hose and attach using hose

clamp. Apply a small amount of silicon based lubricant to the outside of the side

connector to allow an easy fit (see figure 2).

2) Heater – Pool Connections

NOTE: If your pool is plumbed with heavy-duty, reinforced flex hose, contact your

local pool retailer for an available GAME adapter kit (item 4553).

For Pools with 1¼" or 1½" diameter unthreaded hoses GO TO Step A

For Pools that use 2¼" threaded hoses GO TO Step B

A. Pools with 1¼" or 1½" Diameter Unthreaded Hoses

1) Locate the outlet connector on the underside of the solar heater.

2) Using a hose clamp, secure the loose end of your existing pool return hose

to the outlet connector (see figure 3).

SAVE THESE INSTRUCTIONS

AFTER INSTALLING SOLAR HEATER

Connector

Hose Clamp

NOTE: Not shown to scale

Inlet

Figure 1

Hose from

Filter/Pump

(Long Filter Hose)

Reducer

Inlet Connector

(if needed)

Figure 2

Outlet

Connector