AGT INDUSTRIAL AGT-WB24 제품 설명서 - 페이지 11
{카테고리_이름} AGT INDUSTRIAL AGT-WB24에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AGT INDUSTRIAL AGT-WB24 18 페이지.
페이지 인쇄through input
diameter (d) value ：automatically read it from the rim ，input through
2) put down the hood and press
3 There are two ways to check the unbalanced result
3 ．1 set the option SLC to OFF. (stick the block manually)
3 .2 Rotate slowly the tire anticlockwise by hand until the outer side of indicator lights are all on ，at the point of
1 2 O' clock is the unbalance point of alignment plane. Balance alignment planes are as shown in below
pictures. Paste corresponding balance weight on the outside of the wheel rim. See pic. 10
3.3 Rotate slowly the tire anticlockwise by hand until the inner side of indicator lights are all on ，at the point of
1 2 O' clock is the unbalance point of alignment plane. Balance alignment planes are as shown in below
pictures. Paste corresponding balance weight on the inside of the wheel rim. See pic. 11
3.4 After placing the balanced lead, press
see pic. 12. It indicates that the balancing was successful.
(automatic measurement is optional).
key，then the main shaft start to rotate
Pic.10
Pic.11
key to rotate the main shaft. If the operation is correct,we will
Pic.9
11