GAME SolarPRO 4721 소유자 매뉴얼 - 페이지 9

{카테고리_이름} GAME SolarPRO 4721에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GAME SolarPRO 4721 12 페이지. Curve heater
GAME SolarPRO 4721에 대해서도 마찬가지입니다: 소유자 매뉴얼 (13 페이지)

페이지 인쇄

INITIAL OPERATION

Once the SolarPRO has been assembled and the hoses are connected to the filter pump and pool return, unblock the flow of water into

the pool return hose and turn on the pump and filter system. Bubbles will shoot out of the return nozzle into the pool initially while air

is pushed out of the SolarPRO. If this persists for longer than 2 or 3 minutes, check for and repair any leaks in the hoses

or connections.

FOR BEST RESULTS: To reduce heat loss, use a pool cover on your pool overnight, run your filter system during 12:00pm-

6:00pm and cover the pool at night.

MAINTENANCE

The SolarPRO should not require servicing or maintenance other than winterizing. Prior to the first frost, or at the end of your swim

season, the SolarPRO should be removed from its connections to the pool and stored in a frost free location.

Winterizing

Drain all the water from the SolarPRO by disconnecting the tubes. Store in a location protected from frost. Reconnect the pool return

hose to the pool return.

CAUTION: DO NOT ALLOW STANDING WATER INSIDE THE SOLARPRO TO FREEZE. WATER EXPANDS AS IT FREEZES AND CAN

RUPTURE THE SOLAR COILS ON THE SOLARPRO.

TROUBLESHOOTING

Problem

Does not appear to be heating the

pool.

No initial bubbling after SolarPRO is

connected and pump is on.

Bubbles continue to flow out of the

pool water inlet well after the pump

has been turned on.

Leaking SolarPRO

High filter pressure

Possibilities/Solutions

• Check to make sure that water is flowing through the hoses. Check the flow strength at

the pool inlet.

• Has it been sunny?

• Put your pool cover on at night to prevent heat loss.

• If pool water volume is greater than 10,000 gallons, additional SolarPRO units are required.

• If using a bypass kit, check and adjust flow restrictions if necessary.

• Check the setting of the filter to make sure it is returning water to the pool through the

pool water inlet.

• Check that water is flowing through the system.

• Check the connections for a suction leak.

• Check to make sure the flow rate is normal.

• There could be a rupture or break in one or more of the hoses.

• There could be a blockage in one or more of the hoses. If possible, remove the blockage.

• Check the connector seals and replace or repair if defective.

• Flow through SolarPRO may be too high. A bypass kit may be needed.

• Filter may need backwashing or filter medium change.

• Pool system valves may need adjusting.

• Water return outlet may be blocked.

SAVE THESE INSTRUCTIONS