Deagostini Model Space HUMMER H1 매뉴얼 - 페이지 16
{카테고리_이름} Deagostini Model Space HUMMER H1에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Deagostini Model Space HUMMER H1 18 페이지.
페이지 인쇄HUMMER H1: STEP BY STEP
33
33
Tighten each of the
remaining five screws into
the remaining holes lining
the radio box. Once all six
screws are in, tighten each
to fully fasten the box.
37
37
39
39
Slide the 2mm stopper down to the base of
the brake rod. Then, slide over the remaining
length of silicon tubing, followed by the
brake collar (Stage 46). The brake collar
should be put on with the flat side facing
the silicon tube.
Place a 3 × 10mm binding-
head self-tapping screw
into the first of the holes
along the edge of the
radio box.
35
35
Holding the parts in
place, turn the chassis
assembly and tighten the
3mm nylon nut on the
underside of the servo
saver using the arm of the
cross wrench marked '5.5' .
40
40
Push all parts along so they rest against
each other, as shown. Do not tighten the set
screw in the 2mm stopper at this stage.
34
34
Carefully re-insert the
steering rod into the front
servo saver, then tighten
the set screw again to
secure the parts. The
steering rod should be left
in the 'neutral' position
(see Step 24, Stage 47).
38
38
41
41
Insert the free end of the brake rod into the
brake lever (circled).
220
Tighten the screw gently
with a screwdriver.
36
36
Prepare the second 2mm
stopper and 3mm set
screw in the same way as
you did in Steps 19 and
20. Place the assembly
over the free end of the
brake rod.
™