GAME SandPRO 35D 소유자 매뉴얼 - 페이지 12

{카테고리_이름} GAME SandPRO 35D에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GAME SandPRO 35D 20 페이지. Pool filter system

VALVE OPERATIONS

Make yourself familiar with your filter system's valve settings and functions.

Filter Valve Settings & Functions

Setting

Complete Water Flow/Function

Filtration

Vacuum, regular pool filter action. This is the setting the filter will be set to most of the time. In this position, water is

directed through the top of the filter where it compresses and flattens the sand. Contaminants are trapped by the sand

as water makes it way to the bottom strainer, out of the filter and back to the pool.

Rinse

Rinse for no longer than 30 seconds right after backwashing to clean and resettle filter bed. This should always be done

immediately after backwashing, new sand addition or filter start-up. In this position, water is directed to the top of the

tank where it reseats the sand and flushes the valve while sending water out of the waste line. This reduces the chance

of contaminant blow back to the pool when the valve is switched back to the filtration setting after backwashing. Run.

Backwash

Clean filter of captured debris. This is the position needed to clean the filter and sand. You'll know it is time to backwash

when the pressure gauge rises (5 - 10 psi) above its normal reading s(5 - 10 psi) when the filter is clean. In this position,

water is directed through the bottom strainer, reversing the flow through the tank. This causes the sand to separate

and lift while releasing trapped debris out the waste line.

Winterize/

Bypass the filter. This position is ideal for vacuuming pools with large amounts of debris or after an algae treatment. In

Drain

this position, water bypasses the filter and sends all the water and contaminants out of the waste line.

CAUTION: Running the pump in this position will drain water from your pool. Observe water level to prevent

running the pump dry.

Changing Valve Positions

The 4 way valve is designed to provide the required flow rate for each action described above. Always make sure the power source

to the filter is unplugged before changing valve positions. In other words, the pump should not be running when you change valve

settings (i.e. moving from FILTRATION position to the BACKWASH position). Changing valve positions while the pump is running

could result in irreparable damage to the valve and its inner workings. To change valve positions, press down firmly on the valve

lever and rotate to the desired setting.

IMPORTANT: ALWAYS unplug power source to pump before changing valve positions. Changing valve positions while the

pump is running could result in irreparable damage to the valve and its inner workings.

CAUTION: NEVER USE THE VALVE LEVER AS A HANDLE TO CARRY OR LIFT THE FILTER.

SAVE THESE INSTRUCTIONS