GAME SandPRO 50D 소유자 매뉴얼 - 페이지 10

{카테고리_이름} GAME SandPRO 50D에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GAME SandPRO 50D 20 페이지. Pool filter system

CONNECTING THE FILTER SYSTEM

STOP: BEFORE YOU BEGIN TO CONNECT HOSES TO THE FILTER AND PUMP, MAKE

CERTAIN THAT NO WATER CAN FLOW THROUGH THE INTAKE OR RETURN HOSES

CONNECTED TO THE POOL. SOME POOLS HAVE SHUT OFF VALVES IN THEIR IN-

TAKE AND RETURN PORTS, OTHERS DO NOT. IF YOU DO NOT HAVE A SHUT OFF

VALVE, BLOCK THE PORTS WITH A REMOVABLE PLUG TO PREVENT WATER FROM

PASSING INTO AND THROUGH THE HOSES.

NOTE

For Pools with 1¼" or 1½" (32mm or 38mm) Diameter Unthreaded

Hoses use the standard adapters.

For Pools with 2¼" (57mm) Diameter Threaded Hose Connectors

use the threaded adapters for Intex® pools.

These instructions assume that the pool is already assembled with hoses attached to the water intake and return

ports on the pool.

1. Attach a hose connector to the front of the strainer housing and the valve POOL port.

Make certain that the 1½" (38mm) dia o-ring is in the adapter before securing.

2. Attach the pool outlet hose to the hose connector on the strainer housing. Refer to

your pool manual if you are unsure about the inlet/outlet hoses. Secure hose with a

hose clamp or thread onto the adapter.

3. Attach the pool return hose (inlet of pool) to the POOL port adapter on the 4 way

valve. Secure hose with a hose clamp or thread onto the adapter.

Note: Be sure not to secure the return hose to the waste/backwash port.

4. Completed Filter-Pump Installation.

IMPORTANT: Ensure ALL hose connections are tight and the hoses are NOT

kinked or bent at severe angles. If the hoses are leaking, check to make sure

ALL of the parts with o-rings have them attached and are screwed on tightly.

DO NOT overtighten hose clamps (35 in/lb max torque).

CAUTION: DO NOT POWER PUMP AT THIS POINT.

SAVE THESE INSTRUCTIONS