Core GT 사용자 설명서 - 페이지 5

{카테고리_이름} Core GT에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Core GT 12 페이지.

User Manual v1.2

Rigging the kite

Step 5

Push the pump nozzle into the inlet (smaller) valve and start to

inflate the kite.

Step 6

Inflate until the kite is almost full and then turn around until your

back is facing towards the wind.

Step 7

Now fully inflate the kite up to 6-7PSI. Check that all struts are infla-

ted properly. The maximum inflation pressure for the kite is 7PSI. If

the kite is under inflated it has poor performance and the relaunch

can be difficult. Over inflated kites can burst, especially when they

sit in the sun for any length of time.

Step 8

Flip the kite over, position it on its leading edge and weigh down

with lots of sand. A pre-filled linen sandbag is ideal for none sandy

beaches.

Now you can unwind the lines from the bar and attach them to the

kite as shown in the graphic on page 3.