HIKOKI WR14A 취급 지침 매뉴얼 - 페이지 11

{카테고리_이름} HIKOKI WR14A에 대한 취급 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKOKI WR14A 12 페이지.

페이지 인쇄

Read insturction before

use.

Lubricate daily

General Notes

Hold the tool and hav e it running without a load to check the vibration level before using

●

tool. It is a sign for maintenance or repair if excessive vibration level is detected.

Check the free running speed of the tool by hearing the sound generated form the tool

●

before use. It is recommended to check the free running speed of the tool by a tachometer

or stroboscope regularly and after each service .

Keep tool clean after each use to avoid the risk from exposure to hazardous substances

●

deposited on the tool due to work processes .

Follow national legislations for the waste disposal.

●

Always use the accessories recommended by your distributor.

●

Always disconnect the air supply before performing any maintenance on the tool.

●

Lubrication

Air tools require regular lubrication throughout the life of the tool. The air motor and bearing use

compressed air to power the tool. Because moisture in compressed air will rust the air motor,

you must lubricate the motor daily. An inline oiler is recommended.

To lubricate the air motor manually:

Disconnect the tool from the air supply holding it so the air inlet

●

faces up.

Depress the trigger and place one to two drops of air tool oil in the

●

air inlet.

Connect the tool to an air source, cover the exhaust end with a

●

towel and run for a few seconds.

Do not lubricate tools with flammable or volatile liquids such as kerosene, diesel or jet fuel .

●

EXPLANATION OF SYMBOLS

Wear eye protectors.

Wear hearing protectors.

Proper position of a fixed

torque reaction device.

(between the reaction bar

MAINTENANCE

VII Page 14 of 15

Wear half mask s.

Wear half masks.

Risk of crushing

(open-ended

and workpiece)

Direction of

rotation

spanner)