HIKOKI UC 18YSL3 취급 지침 매뉴얼 - 페이지 17

{카테고리_이름} HIKOKI UC 18YSL3에 대한 취급 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKOKI UC 18YSL3 20 페이지.

(2)

Connect the USB cable. (Fig. 3)

Pull back the rubber cover and ﬁ rmly plug in a commercially available USB cable

(appropriate to the device being charged) into the USB port.

(3)

When charging is completed

○ To verify charge status, check the USB device.

○ Unplug the power cord from the electrical outlet.

○ Place the rubber cover over the USB port.

MAINTENANCE AND INSPECTION

Inspecting the mounting screws

Regularly inspect all mounting screws and ensure that they are properly tightened. Should

any of the screws be loose, retighten them immediately. Failure to do so could result in

serious hazard.

Cleaning of the charger

When the charger is stained, wipe with a soft dry cloth or a cloth moistened with soapy

water. Do not use chloric solvents, gasoline or paint thinner, for they melt plastics.

Store idle charger

When not in use, the charger should be stored in dry, high or locked-up place — out of

reach of children.

Service parts list

CAUTION

Repair, modiﬁ cation and inspection of HiKOKI Power Tools must be carried out by

a HiKOKI Authorized Service Center.

This Parts List will be helpful if presented with the tool to the HiKOKI Authorized

Service Center when requesting repair or other maintenance.

In the operation and maintenance of power tools, the safety regulations and

standards prescribed in each country must be observed.

Rubber cover

USB port

USB cable

Fig. 3

English