Gree NEO24HP230V1A 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Gree NEO24HP230V1A에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gree NEO24HP230V1A 12 페이지. High-wall ductless air conditioning & heating system
Gree NEO24HP230V1A에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

TWD-0813-033 Neo Manual REV:Layout 1 9/27/13 11:15 AM Page 17

OPERATION OF WIRELESS REMOTE CONTROLLER

CHANGING BATTERIES AND ADDITIONAL NOTES

To change batteries, slide cover off battery compartment on back of remote controller. Remove

and safely discard old batteries. Insert two new AAA 1.5V dry batteries, using correct polarity.

Reattach back cover.

NOTE:

• If the remote controller will not be used for a long time, remove batteries to prevent

leakage damage.

• Be sure to aim the remote controller at the receiver of the main unit when operating.

• When remote emits a signal, icon will flicker; a tone will be heard when unit receives

that signal.

CHANGING BATTERIES

Remove

old batteries

EMERGENCY OPERATION

Use the Manual Override button to manual operate the unit if the remote controller is lost or

damaged. Lift up the front panel section on the indoor unit and locate the Manual Override button

on the right hand side. Press the Manual Override button to turn ON the unit.The unit will operate

in AUTO mode and will automatically select heating or cooling to maintain room temperature

between 64°F and 77°F. The indoor fan will operate in auto fan mode. Press the Manual Override

button to cancel Manual Override Mode and transfer control back to the remote controller.

Install

new batteries

Manual

Switch

SYSTEM FUNCTIONS

TIME GUARD

The neo System is equipped with many system safeties to provide safe, reliable operation and

comfort.The Time Guard function prevents rapid cycling of the compressor.The system has a

protective 3-minute time delay to restart the compressor after it has turned off.

INTELLIGENT DEFROST

The neo Intelligent Defrost function increases room comfort and saves energy by eliminating

unnecessary defrost cycles. In heating mode, the unit will monitor the outdoor coil for frost build

up. Once frost buildup has been detected, the system will switch into a defrost mode to remove

the frost. In defrost mode the front panel LED display will show "H1" and the indoor fan and

outdoor fan will turn off while the the system removes frost from the outdoor coil. Once the frost

has been removed, the front panel LED display show room setpoint and system will revert back

to normal heating operation.

POWER FAILURE MODE

Power interruptions are no problem for the neo system. User selections and system parameters

are stored in non-volatile memory. These parameters are retained during a power failure.When

power is returned, the neo system will automatically return to the last operating mode.

COLD BLOW PROTECTION

The neo system guards against the annoying COLD BLOW in heating mode.The system

constantly monitors the discharge air temperature. It will delay the indoor fan until the indoor

coil has warmed up to prevent blowing uncomfortable cool air into the room.

POLYMERIC AIR FILTER

The polymeric mesh filters save energy by preventing the indoor coils from being plugged with

dirt and lint.This economical and sturdy filter may be washed, vacuumed and reused.

Optional Function:

PHOTOCATALYTIC FILTER

Photocatalytic Air Filter is a second stage filter that oxidizes and effectively eradicates organic

contaminants in the air.This high-tech filter uses natural ultraviolet light with a titanium dioxide

catalyst to effectively eliminate 99.9% of bacteria and viruses and absorb odors for cleaner,

healthier indoor air.