Dean Forge Dartmoor W5E 사용 설명서 - 페이지 12

{카테고리_이름} Dean Forge Dartmoor W5E에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dean Forge Dartmoor W5E 18 페이지.

To install a multi-fuel kit into a Dartmoor W5 woodburner first remove the inner side bricks by lifting

the baffle plate up on one side above the side brick then slide the side brick out being careful not to

damage it. This needs to be repeated on the other side but this time you must hold the baffle plate to

stop it falling out. Once both side bricks are out the baffle plate can then be removed as well as the log

retainer. On each side of the base of the stove there are two bolts that need to be removed, this requires

a 17mm spanner or socket. The stove is now ready to accept the multi-fuel kit.

1. Bolt the two grate supports (G) by bolting them through the base holes each side. Make sure the

inside nut is adjusted so when the lower nuts are tightened the brackets are not digging into the outer

side brick. The side bricks should just move when the nuts are tight.

2. Fit the new fuel retainer making sure the bars sloping down, away from you towards the base of the

stove.

3. Slide the fuel retainer (B) up then slide the fire grate (A) under the fuel retainer and on top of the side

brackets (G) with the lip on the grate to the front and pointing up. Slide the fuel retainer back down to

sit on the fire grate

4. Re-fit the baffle plate (E) using the new shorter side bricks.

5. Fit the sloping thicker multi-fuel bricks (C) to each side of the fire grate.

6. Fit ash pan (F) under the fire grate.

Page 12 of 18

Installing a Multi-fuel kit in a Dartmoor W5 Eco

Dartmoor W5 Eco with Multi-fuel kit installed

Now you are ready to install the multi-fuel kit.