HIKVISION AE-VC224T-IT 사용자 설명서 - 페이지 4
{카테고리_이름} HIKVISION AE-VC224T-IT에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION AE-VC224T-IT 8 페이지. Vehicle-mounted camera
페이지 인쇄
Safety Instruction
These instructions are intended to ensure that user can
use the product correctly to avoid danger or property
loss.
The precaution measure is divided into "Warnings" and
"Cautions"
Warnings:Seriousinjury or death may occur if any of the
warnings are neglected.
Cautions:Injuryor equipment damage may occur if any
of the cautions are neglected.
In the use of the product, you must be in strict
●
compliance with the electrical safety regulations of
the nation and region.
Refer to technical specifications for detailed
●
information.
Input voltage should meet both the SELV (Safety Extra
●
Low Voltage) and the Limited Power Source with AC
24V or DC 12V according to the IEC60950-1 standard.
Refer to technical specifications for detailed
information.
Do not connect several devices to one power adapter
●
as adapter overload may cause over-heating or a fire
hazard.
Make sure that the plug is firmly connected to the
●
power socket.
When the product is mounted on wall or ceiling, the
●
device shall be firmly fixed.
If smoke, odor or noise rise from the device, turn off
●
the power at once and unplug the power cable, and
then please contact the service center.
If the product does not work properly, contact your
●
dealer or the nearest service center. Never attempt to
disassemble the camera by yourself. (We shall not
assume any responsibility for problems caused by
unauthorized repair or maintenance.)
Make sure the power supply voltage is correct before
●
using the camera.
Do not drop the camera or subject it to physical shock.
●
Do not touch senor modules with fingers. If cleaning is
●
necessary, use clean cloth with a bit of ethanol and
wipe it gently. If the camera will not be used for an
extended period, replace the lens cap to protect the
sensor from dirt.
Do not aim the camera at the sun or extra bright
●
places. Blooming or smearing may occur otherwise
(which is not a malfunction), and affect the endurance
of sensor at the same time.
3