Adexa HEL-707A 사용 설명서 - 페이지 5

{카테고리_이름} Adexa HEL-707A에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Adexa HEL-707A 6 페이지. Electric lava rock grill with cabinet

페이지 인쇄

Instruction Manual

6、 General troubleshooting:

Fault phenomenon

1. Close the switch and turn on

the power supply. The power

indicator is not on or heated.

2. The heating indicator is on,

but the picking board does not

heat up.

3. Heating is normal, but the

indicator is not on.

4. Temperature rise can not be

controlled

The above fault items are for reference only. If any fault occurs, it should stop using

immediately and inform professional personnel to check and repair as soon as possible.

7、Cleaning and maintenance:

1. Before cleaning, power should be cut off to prevent accidents.

2. After working every day, wash with wet towel without corrosive detergent. It is strictly

forbidden to wash the equipment directly with water to prevent water infiltration and circuit

damage.

3. If not used at any time, the thermostat and power switch should be turned off.

4. When not in use for a long time, the stove should be clean and placed in a well-ventilated,

non-corrosive gas warehouse.

8、Transportation and custody

In the course of transportation, violent vibration and collision should be prevented, and no

inversion should be allowed. When not in use for a long time, it should be placed in a well-ventilated,

air-dry, non-corrosive gas warehouse; when temporarily stored, rain-proof and anti-corrosion

measures should be taken.

9、Daily inspection:

Every day before and after use, pay attention to check the status of the machine: before use,

whether the outer box is variant? Is the power cord aged, cracked or damaged? Is the control panel

damaged?

In use: Is there any burnt odor or odor? Is the switch not in good contact? Is the temperature out

of control or leakage?

Daily checks must be carried out regularly. Accidents can be avoided.

If you feel that the circuit is out of order or the temperature is abnormal, you should stop

using it immediately and notify the professional to check and repair it as soon as possible.

Reason

1. There is no power supply

in the circuit.

2. Internal line shedding

1. loosening or falling off of

electric heat pipe wiring

2. At least one of the electric

heat pipes has been burnt out.

1. Indicator lamp burned out

1. Failure of Temperature

Controller

Warning!

Elimination method

1. Check the power supply

2. Investigation and disposal

1. Fastening the connecting

wires and screws at both ends

of the electric heat pipe

2. Replacement of heat pipes

1. Replacement of Indicators

1. Replacement of Temperature

Controller