Majacraft Suzie Professional 매뉴얼 - 페이지 8

{카테고리_이름} Majacraft Suzie Professional에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Majacraft Suzie Professional 12 페이지.
Majacraft Suzie Professional에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지)

페이지 인쇄

7. Crank Assembly

Required:

3 - M5x20mm silver counter-sunk screws

3mm allen T-wrench

The drive wheel has been predrilled with the holes which line up with the holes on the crank

assembly. Make sure the drive belt is on before starting!

Do not fully tighten the centre bolt until you have aligned and started screwing in the two bolts on the

sides.

When the three bolts are all in place, you can finish tightening

them up.

8. Conrods to Pedals

Required:

Posidrive screwdriver

The green joiners have already been put in place in the wooden conrods. Place the wheel in front of

you so the crank and drive wheel are facing you.

We will start with the pedal on your left hand side. Select the conrod that is CLOSEST to YOU. It is on

the end of the curved arm and is attached to the crank assembly with the special right angle rod end

connector. Push the green joiner into the hole at the end of the pedal on your left until it protrudes by

about 2mm. Screw the 25mm gold screw into the hole on the side of the pedal so it holds the green

joiner in place.

Align the holes on the drive wheel with the holes in

the crank assembly and screw it into place using the

3mm Allen key. It is recommended that you insert

the centre bolt first. This will reduce your chances of

possibly scratching your drive wheel.

majacraft