deBont Detti 125 소유자 매뉴얼 - 페이지 3

{카테고리_이름} deBont Detti 125에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. deBont Detti 125 6 페이지. Tube power amplifier

Back

█ Line Input

A single Neutrik Combo series jack/XLR input connector. It will accept a 6.3mm (1/4") jack

(TS or TRS) or XLR plug and will work with both balanced or unbalanced signals. However,

a balanced input signal is preferred over an unbalanced one. An unbalanced 4Vpp or

balanced 2.4Vpp input signal will drive the Detti to maximum power output.

█ Speaker outputs

The Detti is equipped with three Neutrik SpeakOn Combo receptacles. One for each

supported speaker impedance; 2, 4 and 8 ohms. You can use either a 6.3 mm (1/4") jack or

Neutrik SpeakOn plug to connect a speaker cab. It is imperative you only use one speaker

output at a time. Using multiple will impair proper operation and might cause damage to the

amplifier.

Warning: Always have a (speaker)load connected when the amp is turned on. The outputs

are protected, but applying big signal to the input with no load connected might result in

serious damage to the amplifier.

Warning: Only use proper speaker cabling. Never use instrument cables or the likes.

█ Voltage selector

The Detti can be used in countries with mains voltages from 110VAC to 120VAC or from

220VAC to 240VAC. Choose the voltage closest to the actual mains voltage by turning the

selector with a small screwdriver, until it clicks into place. Failure to do so will either cause

the amp to not work properly, or cause serious damage to the inside electronics.

█ Power cord receptacle

The Detti is fed by a IEC 60320 C13 plug, better known as a computer plug. Please make

sure the power cord is undamaged and of proper quality.

█ Power switch

Use this switch to turn the amplifier on or off.

Note: There's no standby switch as seen on most other tube amplifiers. The Detti will take

care of all processes normally associated with standby switches.

deBont Amps Detti 125 Tube Power Amp Owner's manual