CentralPneumatic 62381 소유자 매뉴얼 - 페이지 16
{카테고리_이름} CentralPneumatic 62381에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CentralPneumatic 62381 20 페이지. Hvlp gravity feed
페이지 인쇄Delayed or inadequate cleaning will permanently clog the Spray Gun.
Latex paint hardens quickly and permanently inside Spray Gun.
Troubleshooting - Spray pattern Diagnosis
Note: The drawings on the left below resemble symptoms of spray pattern problems.
Refer to the accompanying possible causes and likely solutions to the right.
problem
Heavy center
pattern
Light center
pattern
Heavy top/
bottom pattern
Pattern on right
or left only
Jerky or
Fluttering Spray
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect air supply before service.
Page 16
NOTICE
Clean the Spray Gun IMMEDIATELY after EVERY use.
possible Causes
1. Pattern Knob partially closed.
2. The paint is too thick.
3. The air pressure is too low.
1. High air pressure.
2. Fluid Knob not open enough.
3. Pattern Knob open too far.
1. Nozzle plugged.
2. Nozzle loose or dirty seal.
3. Dried paint on Fluid Tip.
4. Damaged Fluid Needle.
1. Dirt on one side of Fluid Tip.
2. Holes on one side of
Nozzle are plugged.
3. Damaged Fluid Needle.
1. Loose or damaged Nozzle.
2. Paint level low.
3. Obstruction in Fluid Inlet.
4. Dry or loose Fluid
Needle Packing Nut.
For technical questions, please call 1-888-866-5797.
Likely Solutions
1. Open Pattern Knob more.
2. Thin paint according to the
manufacturer's instructions.
3. Increase air pressure within
the Operating Air Pressure.
1. Reduce air pressure.
2. Open Fluid Knob.
3. Partially close Pattern Knob.
1. Clean Nozzle.
2. Clean and tighten Nozzle and seal.
3. Use a nonmetallic point
to clean Fluid Tip.
4. Replace Fluid Needle and Fluid Tip.
1. Use a nonmetallic point
to clean Fluid Tip.
2. Use a nonmetallic point
to clean Nozzle.
3. Replace Fluid Needle and Fluid Tip.
1. Tighten or replace.
2. Refill paint Cup.
3. Backflush with solvent.
4. Lubricate or tighten Packing Nut.
Item 62381