Adexa ZB-20 사용 설명서 - 페이지 5

{카테고리_이름} Adexa ZB-20에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Adexa ZB-20 5 페이지.

페이지 인쇄

OPERATION PROCEDURES:

1.Unpack the ice maker from it's carton, then remove the ice shovel,

inlet/outlet tubes, and sealing washers, from the container in the ice

maker where they are packed for transit.

2.Position the ice maker on a well ventilated place, leaving at least a

150mm gap between the ice maker and the walls/ceiling etc. The ice

maker must be level, and situated away from any heat source.

3.Attach one end of the φ12mm flexible plastic corrugated pipe to the

water outlet on back of machine. The other end of the pipe should be

inserted into a plumbed in stand waste pipe, or a suitable container

for the collection of the waste water.

4.connect the 3/4" water inlet hose, supplied with the ice maker, to a

drinking water supply and then connect the other end to the water

inlet on the back of the machine. When connecting this hose, use the

sealing washers supplied with the ice maker to eliminate the risk of a

water leak. The water pressure must be a minimum of 1Kg/cm or 14.7

psi and a maximum of 8 kg/cm or 117psi.

5.Plug the power lead in to the supply socket, then press the green on/

off switch on the ice maker to start it, the green " run" light will be lit.

The ice maker will start to operate.

6.The operation of the ice maker is completely automatic unit the ice is

removed from the container. Water supply-ice making-ice transfer-ice

storage.

7.If the storage container is full with ice, the " ice full" indicator on the

display panel will light, and the ice maker will stop automatically.

Remove the ice from the storage container, wait for five minutes, then

restart the ice maker.

8.Should the water supply be restricted or fail, the "water low" light will

be lit. The ice maker will stop automatically. When the water supply is

restored, wait for at least five minutes then re-start the ice maker.

MAINTENANCE:

1.If the compressor stops for any reasons like water shortage, too

much ice, power off, etc., Don't restart it right away. You can

restart it 5 minutes later to protect compressor.

2.Check regularly the connectors of the water inlet and outlet tubes

and drain the little surplus water that may occur.

3.If the ice maker will be unused for long periods of time, please

screw off the plastic drainage connector screw on the back of the

ice maker so as to drain the surplus water in the water groove. Then

screw it on. Wipe the inner liner of the ice storage container with a

clean rag.

4.When plugging or unplugging,

the plug should be held by hand

and the wires should not be

dragged heavily.

5.Please clean the ice maker and its water supply system for one time

every month. The ice maker should be unplugged before cleaning.

TECHNICAL PARAMETERS

(tested under the conditions of ambient temperature 15°C and tap water

temperature 10°C)

Model

ZB-20

ZB-26

ZB-50

The specifications are subject to be changed without notice. Please

check the nameplate for sure.

Ice Making

Ambient

Power

Electric Shock

Capacity

temperature

Input

Protection Class

(Kg/24h)

(W)

≥ 20

145

≥ 26

160

≥50

260

Dimensions

L×D×H

Decibel

(mm)

℃/℉

380×477×590

55db

℃

55db

420×528×655

℃

498×604×831

55db

℃