Majestic MERID36IL 설치 지침 - 페이지 2

{카테고리_이름} Majestic MERID36IL에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Majestic MERID36IL 3 페이지. Glass refractory kit

Figure 3. Glass Refractory Brackets Bent
6. MERIDPLA Only: Place glass brackets in position
and insert screws. See Figure 4 and Figure 5 for ap-
proximate placement. Do not tighten screws at this
time. They may need adjustment once glass panels
are installed.
MERID Only: Remove one screw from the glass shield
and place the retention bracket as shown in Figure 4.
Reinstall the screw, but do not tighten completely at
this time. Repeat this step to install retention bracket
on the other side.
GLASS SHIELD
Figure 4. Retention Bracket Installed
2
BEND 90°
RETENTION BRACKET
(LEFT AND RIGHT SIDES)
Majestic • GL36MER, GL42MER Installation Instructions • 2502-931 Rev. B • 3/18
Figure 5. Glass Refractory Brackets Installed
BEND APPROXIMATELY 90°
LOWER LEG
Figure 6.
7. Bend rear refractory bracket as shown in Figure 6.
8. Remove the existing rear baffle by removing two
screws indicated in Figure 9.
9. Install rear glass refractory panel. The bottom of the
panel is placed behind the tabs that have been bent
upward. See Figure 7. Secure the back glass panel
with the back refractory bracket and self-tapping screw
as shown in Figure 8. Center the rear refractory brack-
et prior to attaching it. It may be necessary to bend the
lower leg of bracket slightly more until it contacts the
glass.
POSITION PANEL BEHIND
BENT TAB
Figure 7. Side View of Bent Tabs