Majestic QUARTZPLA36IN 설치 지침 - 페이지 2
{카테고리_이름} Majestic QUARTZPLA36IN에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Majestic QUARTZPLA36IN 4 페이지.
페이지 인쇄4. If the rear tabs on the left and right basepans are bent
upward, straighten them so they are flat as shown in
Figure 3.
REAR BASEPAN TABS ARE FLAT
REAR BASEPAN TABS ARE FLAT
Figure 3 Straighten Rear Tabs
5. Remove lower glass brackets from packaging and
bend "up" hand bend features. See Figure 4. Install
left and right lower glass brackets by installing them
between the outer edges of the left and right basepans
with the notch facing the front of the appliance. These
pieces will fit tightly against the firebox. See Figure 4.
NOTCH FACES FRONT OF APPLIANCE
Figure 4 Install Lower Glass Bracket (Left Side Shown)
6. Remove the new rear lower glass bracket from the
packaging and bend the hand bend features "up" to
about 45 degrees. See Figure 5. Install the new rear
lower glass bracket with screws removed in Step 3.
Note: The new lower glass bracket spans the entire
width of the back wall of the firebox and rests above
the side lower glass brackets. See Figure 5, Detail A.
2
Majestic • GLQUARTZ36PLA Installation Instructions • 2643-945 • 4/22
BEND TABS UP
Figure 5 Bend Tabs on Lower Side and Rear Glass Brackets
7. Gently pull the pilot tube and pilot wires down,
grasping them from beneath the firebox to remove
slack in pilot wires. Reattach pilot assembly to pilot
bracket.
8. Locate, remove and discard the two screws
located below the rear exhaust hole. See Figure
6.
Install the sleeve onto each 1-1/4 inch (32
mm) screw and install in holes.
REMOVE SCREWS
Figure 6 Remove Screws
REAR GLASS BRACKET
DETAIL A
See Figure 7.