BriskHeat GCW Series 사용 설명서 - 페이지 2
{카테고리_이름} BriskHeat GCW Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. BriskHeat GCW Series 5 페이지. Gas cylinder warmers
페이지 인쇄
Gas Cylinder Warmer (GCW & HCW Series)
TABLE OF CONTENTS
Introduction...........................................................
Safety Alert Symbol..............................................
Important Safety Instructions.............................
Specifi cations.................................................
Operating Instructions.......................................
Troubleshooting Guide...................................
Warranty................................................................
INTRODUCTION
BriskHeat
®
Gas Cylinder Warmers
are designed to heat metal gas
cylinders for condensation control,
pressure increase, and temperature
control in either indoor or outdoor
locations. GCW series are designed
for ordinary locations. HCW series
are designed for CSA Class I
Division I Groups C & D locations.
For successful operation of these
warmers, read and understand
these instructions prior to use.
SAVE THESE INSTRUCTIONS!
Additional copies of this manual are available upon request.
2
BriskHeat
2
2
3
4
4
6
7
SAFETY ALERT SYMBOL
The symbol above is used to call your attention
to instructions concerning your personal safety. It
points out important safety precautions. It means
"ATTENTION! Become Alert! Your Personal
Safety is involved!" Read the message that
follows and be alert to the possibility of personal
injury or death.
Immediate hazards which WILL result in severe
personal injury or death
Hazards or unsafe practices which COULD result in
severe personal injury or death
Hazards or unsafe practices which COULD result in
minor personal injury or property damage.
®
Corporation. All rights reserved.
Gas Cylinder Warmer (GCW & HCW Series)
IMPORTANT SAFETY INSTRUCTIONS
A person who has not read and understood all operating
instructions is not qualifi ed to operate this product.
•
Do not immerse heater in liquid.
•
Keep sharp metal objects away
from heater.
•
Keep volatile or combustible
material away from heater when
in use.
•
Keep enclosure cover tight while
circuits are alive.
Failure to observe these warnings
may result in electric shock, risk of
fi re, and personal injury.
•
Inspect gas cylinder warmer
before use. Do not use warmer
with torn or worn surfaces.
•
Keep enclosure cover tight while
circuits are alive.
•
Do not repair damaged or faulty
warmers.
•
Do not crush or apply severe
physical stress on warmer or
cord assembly.
•
Unplug warmer when not in use.
•
Use gas cylinder warmer for
warming gas cylinder bottles
only. Use specifi c sized heater
with same sized cylinder. Do not
use for other applications.
Failure to observe these warnings
may result in personal injury or
damage to the warmer.
BriskHeat
®
Corporation. All rights reserved.
End User Must Comply to
the Following:
•
Only qualifi ed personnel
are allowed to connect the
electrical wiring.
•
All electrical wiring must follow
local electrical codes.
•
Final installation/wiring is to be
inspected by the authority who
has jurisdiction in the area that
the Gas Cylinder Warmer is
installed.
•
Explosion hazard: Do not
disconnect equipment unless
power has been switched off
or the area is known to be
non-hazardous.
•
The end-user is responsible
for providing a suitable
disconnecting device.
•
The end-user is responsible for
providing suitable
over-protection device. It is
highly recommended that a
ground fault circuit breaker be
used.
3