Centrica Panoramic Power PAN-12 설치 매뉴얼 - 페이지 8

{카테고리_이름} Centrica Panoramic Power PAN-12에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Centrica Panoramic Power PAN-12 11 페이지.

PAN-10 and PAN-12 Sensor installation guide

5. Press the two sides of the opener to release the sensor cover.

Figure 5. Press the opener to release the cover.

6. Open the four screws.

7. Make sure the four core surfaces are free of dust or any other particles.

If necessary, wipe it with a dry cloth

Note Whenever possible, avoid installing the sensor behind wires and position it

at the front of the panel board.

8. Place the opening of the sensor on a clean section of the electrical cable

with the arrow on the label pointing towards the load, so that the sensor

ID and barcode are visible and easily readable.

9. Close the sensor cover, snapping it into its place (in 225A screw back the

cover) and making sure that all four pins are properly inserted and the

sensor is tightly closed.

10. You can learn more about sensors installation

Revision 1.4 January 2018

Registered in England & Wales No 3033654

in this video clip.