Bristan 1901 피팅 지침 및 내용물 목록 - 페이지 3

{카테고리_이름} Bristan 1901에 대한 피팅 지침 및 내용물 목록을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan 1901 8 페이지. Sink mixer
Bristan 1901에 대해서도 마찬가지입니다: 피팅 지침 및 내용물 목록 (9 페이지), 피팅 지침 및 내용물 목록 (4 페이지)

페이지 인쇄

IRN R001

See text of entry for Installation Requirements or Notes.

IRN R040

The fitting shall be installed so that its outlet discharges above the spill-over level of any fixed

appliance as 1nd1cated below:-

For backflow protection in domestic or installations up to. and including. Fluid Category

Size of tap or combination fitting.

1. Not exceeding 1/2 In

2. Exceeding 1/2 In but not exceeding 3/4 In

3. Exceeding 3/4 In

If the fitting cannot be installed as indicated in the table it shall be installed:

a) with an approved double check valve assembly or some other no less

effective backflow prevention device immediately upstream of the inlet; or

b) so that it draws water by gravity only from a cistern, or cylinder having a

permanently open vent pipe, and the distributing pipe supplies no other fitting

(other than draining tap) at a lower level.

For backflow protection in premises or installations up to. and including Fluid Category

The vertical distance of the outlet above the spill-over level shall be not less than 20mm or twice the

diameter of the inlet pipe to the fitting, whichever is the greater.

If the fitting cannot be installed as indicated it shall be installed with a backflow prevention

arrangement suitable for the Fluid Category.

Cleaning & Maintenance

Your fitting has a high quality finish and should be treated with care to preserve the visible surfaces. All finishes will

wear if not cleaned correctly. The only safe way to clean your product is to wipe with a soft damp cloth.

Stains can be removed using washing up liquid. All bathroom cleaning product (powders and liquids) will

damage the surface of your fitting, even the non-scratch cleaners.

The hardness of the water in your area will determine how often you should clean and service this product.

Please refer to the Map of Hard Water Areas, on the following page.

NOTE: -

Never use abrasive detergents or disinfectants or those containing alcohol, hydrochloric or phosphoric

acid.

Traditional type valves: - If the fitting leaks from the spindle

•

Remove fitting head [if necessary).

•

Tighten gland nut on top of valve.

All valve types: - If the fitting begins to drip

•

Turn off the water supplies.

•

Remove fitting head and valve.

•

Carefully clean seating and rubber washer.

•

Replace valve and turn on the water supplies.

•

If the problem persists contact our customer service helpline.

Bristan recommend E-Cloth for cleaning all of our bathroom

Using Just water, E-cloth gives a smear free, deep clean by breaking up and holding

dirt, which normal cloths leave behind. Order through your Bristan stockist.

(ORDER CODE: ECLOTH)

Schedule 2-15 (1]

Vertical distance of outlet above spill-over level.

20mm

25mm

70mm

kitchen products.

BRISTAN