Decagon AQUA LAB VSA 빠른 시작 매뉴얼 - 페이지 8
{카테고리_이름} Decagon AQUA LAB VSA에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Decagon AQUA LAB VSA 12 페이지. Vapor sorption analyzer
페이지 인쇄V S A Q u i c k S t a r t G u i d e
• For DDI method
•
To choose the starting a
highlighted and then cycle to the desired value using
the up and down arrows. Any value between 0.03 and
0.95 a
can be chosen including "current". Choosing
w
"current" means that the stage will start at the initial a
of the sample. Press when finished.
• To choose the final a
and then cycle to the desired value using the up and
down arrows. Any value between 0.03 and 0.95 a
be chosen including current (see "current" definition
above). Selecting a final a
starting a
final a
higher than the starting a
w
Press when finished.
•
To choose the temperature of the stage, press with
"Temperature" highlighted and then cycle to the
desired temperature using the up and down arrow keys
(hold down arrows for accelerated scrolling). You may
choose any temperature between 15 and 60 °C, 25 °C is
default. Each stage can run at a unique temperature.
•
To choose the desired
"Resolution" press with "Resolution" highlighted and
then cycle to the desired value using the up and down
arrows. You may choose any value between 0.003
and 1.0
a
resolution. Setting a higher resolution value makes
w
the test faster, but decreases the
recommend a DDI resolution of 0.01
•
To choose the air flow rate, press with "Flow"
highlighted, and then cycle to the desired value using
the up and down arrows. Any value between
10-163 ml/min can be selected. Higher flow rates will
speed up the test, but may result in lower data
resolution and non-equilibrium conditions. The
default value of 100 ml/min is suitable for most
products.
, press with "Final" highlighted
w
will result in desorption, while selecting a
w
a
. The resolution for DDI determines the target
w
, press with "Start"
w
that is lower than the
w
results in adsorption.
w
a
resolution, highlight
w
a
resolution. We
w
can
w
a
.
w
w