Airflex AF5D-21 사용자 설명서 - 페이지 4

{카테고리_이름} Airflex AF5D-21에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Airflex AF5D-21 10 페이지. 2d/3d multi-projector stacking processor

Installation process for 3D display

1. DVI to HDMI adapters or DVI to HDMI cables are required if the connection with video source or projectors

is not through DVI port.

2. Connect AF5D with signal source, RH output to RH eye projector and LH output to LH eye projector.

3. Reset AF5D to factory default settings via OSD [Option] menu to ensure no unexpected settings.

4. Install polarizer into RH & LH projectors before two projector image alignment. Make sure RH/LH

polarizers are set in correct projector, direction and angle with distance of 5-15cm to the lens to avoid

thermal damage.

5. Blue Ray player should be set at AUTO 3D (or 1080p@24Hz) for 1080p frame packing 3D display.

6. Turn on all devices. Some projector will search input source several times due to input timing change and

HDCP validation. AF5D will automatically connect to input source. Then the screen will show up with

double images. If no input source is detected, AF5D will go into power saving mode. The screen will show

[Power Saving Mode] message.

7. Select correct input source and set output resolution to match projector native resolution.

8. Make sure two projectors are in good focus and have the same settings.

9. Align two projector images overlapped together through projector keystone correction or lens shift.

10. Activate AF5D [3D Properties] menu to get correct input format and 3D settings.

11. Press [L/R ID] key on remote controller or front panel to confirm the right setting in RH/LH channels.

12. Test the final result and 3D performance.

Procedures for 3D display setting in AF5D

If the projector can accept 1080P@24Hz timing, please enable [1080P 24Hz output] to get better video

image, otherwise AF5D-21 will output 1080P 60Hz signal.

www.airflex5d.com

1. After image position alignment, to activate [3D

Properties] in OSD to select 3D formats.

2. Select [Automatic] if the 3D signal is standard 3D

formats from Blue Ray player.

3. Select [Side By Side] or [Top-Bottom] based on

user's 3D input sources.

4. Default setting is [Automatic]

1. Activate [Identify] menu to show "R & L"

characters on the screen at the same

time to verify the final 3D settings.

2. RH eye should see only "R" and LH eye

should see only "L".

-3-