Bristan Descent DSC FSBSM C 설치 지침 및 사용자 설명서 - 페이지 9
{카테고리_이름} Bristan Descent DSC FSBSM C에 대한 설치 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan Descent DSC FSBSM C 16 페이지. Tap
Bristan Descent DSC FSBSM C에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (16 페이지)
페이지 인쇄
Installation
Basin Mixer / 1 Hole Bath Filler
1. Screw the flexi tails into the bottom
of the body by hand only (DO NOT
OVERTIGHTEN).
2. Feed the flexi tails through the
hole in the basin / bath, ensuring
the washer is fitted between the tap
body and fixing surface to ensure a
water tight seal.
3. Screw the fixing rods into the
bottom of the tap body. Slide the 'C'
shaped rubber washer and 'C' shaped
metal washer onto the fixing rods up
to the underside of the basin/bath.
4. To secure the tap body in place
tighten the fixing nuts onto the
fixing rods until the are fully
tightened against the 'C' shaped
metal washer. The fixing nuts can be
tightened with a suitable spanner.
5. Connect the flexible tails to the hot
and cold water supplies.
6. Turn on both water supplies,
operate the handle in both directions,
letting the water flow for a few
minutes to flush through the system.
7. Fit the clicker waste (for basin
mixer only) ensuring the rubber
washer is fitted between the basin
and the waste. Place the other rubber
washer under the basin and secure
by tightening the backnut, in order to
fill the basin, the button in the middle
of the waste needs to be pressed
down. To release the water, press the
button again.
8. Check all joints and connections
for any leaks.
Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.
9