Bristan DSC WMBAS C 설치 지침 및 사용자 설명서 - 페이지 9

{카테고리_이름} Bristan DSC WMBAS C에 대한 설치 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan DSC WMBAS C 18 페이지. Descent tap range
Bristan DSC WMBAS C에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (16 페이지)

페이지 인쇄

Installation

3 Hole Basin Mixer/ Bath Filler

1. With the backnut, metal and rubber

washer fitted to the side body threaded

tail, put the side body through the hole in

the basin / bath from underneath.

2. Screw the shroud, ensuring the washer

is fitted between the shroud and basin /

bath, onto the threaded tail and tighten

backnut underneath onto the bottom of

the basin/bath. The screws on the

backnut allow for any uneven surfaces

and should be tightened up to metal

washer. Replace the handle, grub screw

and the cap.

3. Fit the spout to the basin/bath

tightening the backnut. The screws on

the backnut allow for any uneven

surfaces and should be tightened up to

metal washer.

4. Attach the T- joint assembly and

connect to the side bodies (hot on the

left, cold on the right when viewed from

the front), by using the flexi tails supplied.

5. Connect the hot and cold water

supplies to the side bodies (hot to the left,

cold on the right hand side), fully open

both valves, letting the water flow for a

few minutes to flush the system.

6. Fit the clicker waste (basin mixer only)

ensuring the rubber washer is fitted

between the basin and the waste. Place

the other rubber washer under the basin

and secure in place by tightening the

backnut. In order to fill the basin, the

button in the middle of the waste needs

to be pressed down. To release the water,

press the button again.

7. Check all joints and connections

for leaks.

Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.