Bristan DUL3 THBSM C 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Bristan DUL3 THBSM C에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan DUL3 THBSM C 20 페이지. Thermostatic bath shower mixer

General Information

This product has been tested to the Water Regulations Advisory Scheme (WRAS) and

satisfies the requirements of the Water Supply (Water Fittings) Regulations 1999 and

current bylaws. For full Installation Requirements & Notes (IRN) please visit

www.wras.co.uk/directory.

This product has been designed and tested to comply with BS EN1287:1999 (LP)

and BS EN 1111:1999 (HP) Thermostatic Mixing Valves Standards.

BS 8558 recommends hot water should be stored and distributed at a temperature of

not less than 60ºC which will help minimise the build-up of lime scale in hard water

areas.

If installing this product on a low pressure (tank fed) system please see

specificationstable on page 5 to determine the minimum distance required from

undeside of the cold water tank to the outlet.

These Thermostatic Mixing Valves should be installed in compliance with the Water

Regulations. Where the supplies are unbalanced, i.e. Hot water from cylinder tank / cold

from the mains, approved check valves must be fitted in the supply pipes.

If in doubt, contact a registered Plumber or your Local Water Authority or the Secretary

of The Institute of Plumbing, address as follows:

The Institute Of Plumbing

64 Station Lane,

Hornchurch

RM12 6NB

Phone: 01708 472791

Need help? Give us a call on 0844 701 6273 and speak to one of our trained advisers.