Bristan EV KIT-EEVK C 설치 지침 및 사용자 설명서 - 페이지 11
{카테고리_이름} Bristan EV KIT-EEVK C에 대한 설치 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan EV KIT-EEVK C 12 페이지. Evo riser rails and kits
페이지 인쇄Troubleshooting
Symptom
Cause
Partially closed isolation valve.
Instantaneous water heater
cycles on and off as flow rate
or pressure is too low.
Head of water is below the
minimum distance required.
No flow or
Airlock or partial blockage in
low flow
the supply pipework.
rate
Inlet filter in shower valve is
blocked
Check the shower head, hose
and filters for any blockage.
Shower hose is kinked, causing
a blockage.
This is normal for a short time
after using the shower.
Water
leaking
from
shower
head
Shower valve failing to close
fully, possibly due to water
borne debris.
Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.
Remedy
Open isolation valve.
Increase water flow rate or
pressure through system.
Refer to the shower valve's
instruction booklet for
minimum distance required.
Flush through pipework to
ensure removal of debris and
any airlocks.
Refer to the shower valve's
instruction booklet for
guidance.
Clean as per the Maintenance
section.
Un-kink the shower hose.
Replace if damaged.
This is caused by residual water
tension, the build up of water
in the shower. Adjust the
angle of the shower head as
necessary to vary draining
time.
Refer to the shower valve's
instruction booklet for
guidance.
11