Bristan IRBS4-CP 설치 지침 및 사용자 설명서 - 페이지 8

{카테고리_이름} Bristan IRBS4-CP에 대한 설치 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan IRBS4-CP 16 페이지. Infrared temperature control automatic basin spout
Bristan IRBS4-CP에 대해서도 마찬가지입니다: 설치 지침 및 사용자 설명서 (20 페이지)

페이지 인쇄

Installation - Electrical Connections

Connect Power Supply Cable

Before starting any electrical

work ensure the power supply

is isolated.

Wire the electrical power cable into a

switched fused spur off the ring main.

The blue wire should be wired to the

neutral connection and the brown

wire should be connected to the live

connection.

Note: For full electrical requirements see

'Electrical Connections' in 'Installation

Requirements' section.

Important: This product must be

permanently connected to the fixed

wiring of the mains supply using the

factory supplied power cable.

Power/ Sensor Cable Connection

Connect the transformer cable to the

sensor and battery box connectors.

Attach The Wall Bracket

Attach the wall bracket to the wall by

using screws and wall plugs provided.

Place the battery box into the battery

housing bracket and attach to the wall

bracket.

Setting Up The Sensor

Once the tap has been installed,

disconnect the sensor connector from

the transformer cable for 30 seconds,

Reconnect and put the hand at the

required position in front of the sensor

until the light stops flashing.

Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.

Transformer cable

Battery Box

Battery Housing

Bracket

Sensor

connector

Battery box

connector

Wall Bracket