Bristan Java J BASNW COM 피팅 지침 및 내용물 목록 - 페이지 2
{카테고리_이름} Bristan Java J BASNW COM에 대한 피팅 지침 및 내용물 목록을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan Java J BASNW COM 2 페이지. Single lever basin mixer (without waste)
페이지 인쇄
WATER PRESSURE
This mixer is suitable for use at all supply pressures. However for
optimum use both the hot and cold supplies should be reasonably
balanced. If the fitting is installed at low pressure (tank fed), then the
minimum distance from the outlet of the nozzle to the underside of
the cold tank should be approximately 2.0 metres to ensure
adequate performance.
This mixer should be installed in compliance with Water Regulations.
Where the supplies are unbalanced, i.e. hot water from the cylinder
tank/cold from the mains, approved check valves must be fitted in
the supply pipes. For further details contact your Local Water
Authority.
1
2
3
4
5
6
7
8
9
10
11
Please note: In the unlikely event you find a part missing please
contact our Customer Service Helpline on 0844 701 6273 or email
[email protected] for immediate dispatch of part.
13
14
'C' PLATE
FIXING KIT
12
CONTENTS
Head
(x1)
1.
Shroud
(x1)
2.
Retaining Nut (x1)
3.
Cartridge
(x1)
4.
Body
(x1)
5.
Plinth
(x1)
6.
Full Washer
(x1)
7.
INSTALLATION
1.
Identify all components and check for completeness,
particularly before arranging fitting.
2.
Fit the mixer body to the basin using the 'C' plate fixing kit. The
plinth (6) and full rubber washer (7) go between the fitting (5)
and the basin, and the 'C' shaped rubber (8) and metal washers
(9) on the underside of the basin. To be secured using the nuts
(10) and threaded rods (11).
3.
Fit the inlet connection tail pipes (12) to the fitting and connect
the hot and cold supplies.
4.
Fully open the mixer in the mid position, letting it run for a few
minutes to check all joints and connections for leaks.
5.
See over the page for aftercare instructions.
MAINTENANCE
If the fitting begins to drip:
Turn off the water supply.
1.
Remove indice cap (14), loosen grub screw (13) with 2.5mm
2.
hexagon key and pull off head (1), unscrew retaining nut (3).
Remove cartridge (4).
3.
Clean or replace cartridge, clean and grease seal and refit.
4.
Note: that there are locating pins on the bottom of the cartridge that
fit in holes inside the tap, to ensure it is fitted the right way round.
Replace cartridge and head and turn on the water supply.
5.
Contact our helpline if problem persists.
6.
8. Rubber 'C' Washer
9. Metal 'C' Washer
10. Nut
11. Threaded Rod
12. Tailpipe
13. Grub Screw
14. Indices cap
(x1)
(x1)
(x2)
(x2)
(x2)
(x1)
(x1)