Aguilar DB 728 매뉴얼 - 페이지 4

{카테고리_이름} Aguilar DB 728에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aguilar DB 728 5 페이지. 400-watt tube power amp

If your speaker cabinet is 8 ohms (this information is usually on the jack plate of the

speaker cabinet) simply set the impedance switch to 8 ohms. The same applies for a

single 2 or 4 ohm cabinet.

If you are using two 8 ohm cabinets in parallel (both connected directly to the

back of the amp), the impedance value is halved, and the impedance switch should be

set to 4 ohms. For two 4 ohm cabinets, set the impedance switch to the to 2 ohm

setting.

Your amp needs to be set at the proper impedance for full power and reliability.

Fan Switch:

Rear Panel

The fan is ultra quiet, and is always on to provide the necessary cooling to the

components. There is a low speed setting for use in the quietest environments. We

recommend using the high speed whenever possible as this will help facilitate the

longest tube life.

Signal Ground Lift:

The signal ground lift jumper, located on the rear panel, connects the audio circuit

ground to the chassis ground (earth). This should be left in place under most

circumstances. An exception would be if connecting an external preamp to the DB

728 causes an audible ground loop. In this case removing the signal ground jumper

will eliminate the ground loop. Note that this can be done only when an external

device is connected to the input of the DB 728. With the signal ground jumper

removed, the DB 728 will hum in the absence of a connection.