Adexi 81560007 매뉴얼 - 페이지 10
{카테고리_이름} Adexi 81560007에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Adexi 81560007 16 페이지.
페이지 인쇄3. After inserting the battery, the remote
sensor LED indicator will light for 4
seconds, and then flash once per
60 seconds thereafter. Each time it
flashes, the sensor is transmitting
data.
4. Close the battery door.
2.4 DISPLAY CONSOLE SET UP
1. Move the remote thermometer(s)
about 2 to 3 m away from the display
console (if the sensor is too close, it
may not be received by the display
console).
2. Remove the battery door on the back
of the display, as shown below. Insert
one AA (alkaline or lithium, avoid
rechargeable) battery in the back of
the display console.
1. Suspension eye for wall hanging
2. Desk Stand
3. °C / °F button
4. High / Low Record button
5. Battery Compartment
6. Battery Compartment door
All of the LCD segments will light up for
a few seconds to verify all segments are
operating properly.
UK
3. Replace the battery door, and fold out
the desk stand and place the console
in the upright position.
The console will instantly display
indoor temperature and humidity. The
remote temperature will update on the
display within a few minutes.
While in the search mode, the
reception search icon
If the remote does not update, please
reference the troubleshooting guide in
Section 7.
2.4.1
Display Console Layout
1. Outdoor Temperature
2. Indoor Temperature
3. Indoor Humidity
4. Outdoor Temperature High / Low
Record
5. Indoor Temperature High / Low
Record
6. Indoor Humidity High / Low Record
7. Wireless Reception Icon
10
flash.