DecaLED Touch Panel DMX 4 매뉴얼 - 페이지 4

{카테고리_이름} DecaLED Touch Panel DMX 4에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DecaLED Touch Panel DMX 4 5 페이지.

페이지 인쇄

NOTE: In the process of adjusting brightness and speed, the toggle produces clicks. However, the click

disappears when the toggle reaches the maximum/minimum value.

5. Color

To enable Color Menu, hold on pressing the "Color" key for about 1s, the key clicks and the indicator lights up.

Then rotate the touch toggle to adjust the RGB value until you get the desired color.

5.1 Setting a color

Up to 4 colors can be configured and stored into the memory of the device in manual mode. Each figure key

corresponds to one color. The procedure to assign a color is described below:

•

Touch "Color" key to enable Manual Mode, the key clicks and the indicator is lit.

•

Rotate the touch toggle to adjust RGB value until you get desired color.

•

Touch any of the figure keys to which you wish to record the color, and hold on for more than 2 seconds.

•

All indicators flash momentarily once to indicate the current parameters, including the value of color and

brightness, have been saved into the key.

•

Repeat these step to save a color to the other 3 figure keys.

5.2 Playback color

Touch "Color" key to enable Manual Mode. Then touch the corresponding button of 1~4 to select the color

which you have assigned to the key. The LED indicator lights up and it starts to display the stored color.

5.3 Setting Fadetime for Color Exchange

To set the fadetime for color exchange, you take the following procedures:

•

Touch "Color" key and hold on for 5 seconds till all LED indicators flash once. Then release the key and the

"Color" key flashes repeatedly.

•

Touch any one of these keys--1, 2, 3, 4, Program, Color, Brightness or Speed.

•

All indicators flash momentarily once to confirm the setting.

•

The existing mode ends and changes to normal mode automatically.

Different keys represent different fadetime:

6. Scene

6.1 Customizing a scene

Up to 4 scenes can be recorded and played back in this mode. Each figure key corresponds to one scene.

The procedure to record a scene is described below:

•

Touch "Program" or "Speed" key to enable Auto Mode, the key clicks and the LED indicator lights up.

•

Rotate the touch toggle to select 1 of 10 built-in programs or adjust the speed.

•

Touch any of the figure keys to which you wish to record the scene, and hold on for more than 2 seconds.

•

All indicators flash momentarily once to indicate the current parameters (including the built-in program

and the value of speed and brightness) have been recorded and saved into the key.

•

Repeat these step to save more scenes to the other 3 figure keys.

6.2 Playback scene

Touch "Program" or "Speed" key to enable Auto Mode. Then touch the corresponding button of 1~4 to select

the scene which has been assigned to it. The LED indicator lights up and it starts to display the recorded scene.

6.3 Scene record lock/unlock

Keys

Fadetime

P/C/B/S

0s (no fade)