Bristan Wine Easyfit 설치 지침 및 사용자 설명서 - 페이지 10
{카테고리_이름} Bristan Wine Easyfit에 대한 설치 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan Wine Easyfit 12 페이지. Kitchen sink mixer
페이지 인쇄Troubleshooting
Symptom
No flow or poor flow
rate.
Water dripping for a few
seconds after the tap
has been turned off.
Constant dripping /
leaking when the tap is
not in use.
Fitting does not turn on.
10
Cause
Partially closed stop or service
valve in water supply pipework to
the tap.
Head of water is below the
minimum distance required.
Possible airlock / blockage in
supply pipework
Cartridge / Valve not opening
fully.
This is caused by 'capillary
action' and residual water in the
spout being siphoned out. This
should only last for a couple of
seconds.
Cartridge / Valve not fully
shutting off.
Water supplies not turned on.
Closed stop or service valve.
Remedy
Open stop or service valve.
Refer to the Specification section
for minimum pressures required.
Remove water supplies from the
fitting and flush the system to
remove any airlocks / debris.
Service fitting. Refer to
maintenance section on page 09.
Service fitting and replace
cartridge / valve. Refer to
maintenance section on page 09.
Check that the water supplies to
the fitting are turned on.
Open stop or service valve.