Bristan Z TC 1/2 C 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Bristan Z TC 1/2 C에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan Z TC 1/2 C 16 페이지. Temperature controlled time flow tap

Speciﬁ cations

Inlet Connections:

15mm Compression ﬂ exible connecting pipes

Minimum working pressure: 1.0 bar

Maximum working pressure: 5.0 bar

Maximum static pressure: 10.0 bar

System Requirements:

Gravity fed hot & cold (Equal pressures)

Gravity fed hot & cold (Differential pressure, maximum ratio 5:1)

Unvented systems

Instantaneous water heater (Combination boiler)

Timed Flow: 15 Seconds ± 5 Seconds

This product has been tested to the Water Regulations Advisory Scheme (WRAS) and

satisﬁ es the requirements of the Water Supply (Water Fittings) Regulations 1999 and

current bylaws.

For full Installation Requirements & Notes (IRN) please visit www.wras.co.uk/directory.

Designed to comply with and to be used within systems designed to BS 6700.

BS 6700 recommends the temperature of stored water should never exceed 65°C.

A stored water temperature of 60°C is considered sufﬁ cient to meet all normal

requirements and will minimise the build up of lime scale in hard water areas.

If the ﬁ tting is installed at low pressure (tank fed), then the minimum distance from the

highest installed position of the outlet to the underside of the cold tank should be at

least 10 metres to ensure adequate performance.

These taps and mixers should be installed in compliance with the Water Regulations.

Where the supplies are unbalanced, i.e. Hot water from cylinder tank / cold from the

mains, approved check valves must be ﬁ tted in the supply pipes.

For further details contact your Local Water Authority.

Need help? Give us a call on 0844 701 6273 and speak to one of our trained advisers.