Bristan Z2 SQR 1/2 C 피팅 지침 매뉴얼 - 페이지 5

{카테고리_이름} Bristan Z2 SQR 1/2 C에 대한 피팅 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan Z2 SQR 1/2 C 12 페이지. Tap
Bristan Z2 SQR 1/2 C에 대해서도 마찬가지입니다: 설치 지침 및 사용자 설명서 (2 페이지)

페이지 인쇄

4. Dimensions (cont).

Z2 BIB C

Installation

Prior To Installation:

If the supply pressure is above 3 bar a pressure reducing valve must be fitted. All supply pipework should be

thoroughly flushed before connecting to the taps to remove any debris in the pipework. Taps should also be

installed without using of any sealants. Waterborne debris may damage internal parts. Damage caused by

waterborne debris will invalidate the guarantee.

If the fitting is installed at low pressure (tank fed), then the minimum distance from the highest installed position of

the outlet to the underside of the cold water tank should be at least 2 metres to ensure adequate performance.

Operating pressures: Min 0.5 bar, Max 5.0 bar

1. Identify all components are present prior to installation.

2. Assemble and fix the tap as shown in the relevant diagram, (see pages 6-8).

NOTE:- If the supply pressure is above 1.0 bar it may be advisable to fit the 5 litre per minute flow regulator.

The flow limiter should be fitted to the tail of the tap with the arrow pointing upwards and the 'O' ring at the base.

3. Connect the water supply to the tap.

4. The tap is supplied with both red and blue indices, for either hot or cold use. Please ensure that the correct

indice is fitted to the correct tap.

5. Turn the water supplies on and operate the tap several times to flush the system.

6. Check all joints and connections for leaks.

Indice

Flow Regulator