AFPV SN-AAT 사용자 설명서 - 페이지 5

{카테고리_이름} AFPV SN-AAT에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AFPV SN-AAT 6 페이지. Auto antenna tracker
AFPV SN-AAT에 대해서도 마찬가지입니다: 매뉴얼 (6 페이지)



PRE-FLIGHT CHECK

GPS connected

FC positioned and AAT connected

normally can take off.

Step1: Download upgrade software and drivers and install：install "CP210x USB to UART Bridge" driver .

https://github.com/HelloLeFei/SN_L/releases

www.lefeirc.com

Step2: Connect via USB

：

Step3: Upgrade SN_AAT

Step1: power off AAT at first

Step2: Select "AAT"

Step3: load firmware and flash,

Step4: Before the end of the countdown, power on AAT

6. FAQ

Q：Communication is normal but cannot be tracked.

A：Check if the servo is in tracking mode; When the AAT is connected to the GPS, check whether the AAT

is unlocked, after unlocking, the number of satellites stops flashing; Check if the SN meets the takeoff

conditions.

Q：Horizontal pointing is not accurate.

A：When the compass is not enabled, check the angle error by <CLI>; When the compass is enabled, check

if the calibration is correct and there is interference around.21qz

Q：Vertical pointing is not accurate.

A：<CALIBRATION> -- <angle calibration>.

Select correct com ID.

GPS not connected

Place the aircraft near the AAT (within 3m) and take off

when the FC is positioned.

SN-AAT