Bristan FLT WMBAS C 설치 지침 매뉴얼 - 페이지 10

{카테고리_이름} Bristan FLT WMBAS C에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan FLT WMBAS C 16 페이지. Flute tap range

Installation Cont.

Wall Mounted Basin Mixer / Bath Filler

1. Decide on the final position of the basin mixer/

bath filler. Install suitable battons onto the wall

cavity if required.

2. Plumb the hot and cold water supply pipes to

the required position ensuring the hot is on the

left and cold is on the right when viewed from the

front.

3. Secure body using the screws and wall plugs

supplied.

4. Attach pipework to the hot and cold inlets (hot

on the left and cold on the right when viewed from

the front) ensuring the olive is fitted to the copper

pipe work. Tighten the compression nut to secure

pipework and create a water tight seal.

Note: Before finishing the wall surface turn on the

water supplies to check for any leaking

connections.

5. Finish the wall surface.

Note, it is important sufficient thread is left

exposed to allow the spout to connect.

6. Push the plate onto the body upto the wall

surface.

7. Fit the spout and tighten the grub screws to

secure in position.

8. Screw the shroud onto the valve and secure

by tightening the grub screw. Screw the locking

shroud onto the shroud.

9. Push the handle onto the valve shroud and

tighten the grub screws.

10. Turn on both water supplies and operate the

handle letting the water flow for a few minutes to

flush the system.

Need help? Give us a call on 0844 701 6273 and speak to one of our trained advisers.