Bristan Java 피팅 지침 - 페이지 2

{카테고리_이름} Bristan Java에 대한 피팅 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan Java 2 페이지. Basin and bath taps

WATER PRESSURE

These taps are suitable for use at all supply pressures. If the taps are

installed at low pressure (tank fed), then the minimum height from the

outlet of the nozzle to the underside of the cold tank should be 1.8

metres to ensure adequate performance.

These taps should be installed in compliance with Water Regulations.

For further details contact your Local Water Authority.

INSTALLATION

1. Identify all components and check for completeness, particularly

before arranging fitting.

2. Install the taps into the basin, bath or sink, using the washers and

backnuts provided.

3. Connect the hot and cold water supplies.

4. Turn on the water supplies. Open both taps letting the water flow for

a few minutes to flush the system.

5. Check all joints and connections for leaks.

6. See over the page for aftercare instructions.

PRISE OFF CAP

MAINTENANCE

If the fitting begins to drip:

1. Turn off the water supply.

2. Prise off cap, loosen grub screw with 2.5mm hexagon key and pull off

head.

3. Remove valve.

4. Carefully clean seating, rubber washer and ceramic disc.

5. Replace valve and head and turn on the water supply.

6. Contact our helpline if problem persists.

CD VALVE

Please note: In the unlikely event you find a part missing please

contact our Customer Service Helpline on 0844 701 6273 or email

[email protected] for immediate dispatch of part.

CLEAN WASHER

AND SEAT