AIRFLO ZB-250 사용 설명서 - 페이지 7

{카테고리_이름} AIRFLO ZB-250에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AIRFLO ZB-250 9 페이지.

Step 1.9

Put a bucket beside the unit

and then switch on the water

filling controller to let the

water flow over the filter for

30 seconds until the water

from left side is clean

Step 1.10

Take off the anti-drain plug

from the back of the unit

then connect to the water

pipe (the left one)

Step 1.11

Insert the water filling pipe

(1m) to the drain hole (the

right one)

Step 1.12

If you need to take off the

pipe or replace it, do as

follows:

First, take off the blue ring

labeled A then press the

white ring at the outer side

labeled B. Lastly, take out

the pipe.

Step 2 Plug in.

Step 3 Timer setting: Before pressing the ON/OFF button, press the TIMER/CLEAN button.

The TIMER indicator will then light up. Press + or - button to adjust the timer. If the timer function

is set, the indicator will light up.

Step 4 Press ON/OFF button, the unit will then start to make ice. LED screen will show

ambient temperature.

Step 5 Adjustment of ice making time: You can change the ice size by adjusting the ice making

time as follows: When the LED screen flashes, press + or - to adjust the ice making time for the

next cycles. One press of the + button and the number 1 will be shown on the screen. The ice

making time for the succeeding cycles will be one minute more (than the 10-minute default).

To elaborate: if you press + button once, "1" will be shown on the screen, which means that the

- 7 -