Decathlon BMX 매뉴얼 및 보증 지침 - 페이지 14

{카테고리_이름} Decathlon BMX에 대한 매뉴얼 및 보증 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Decathlon BMX 17 페이지.

페이지 인쇄

BMX BIKES

Rotor

1/Changing and adjusting rear brake cables:

Assemble the lower cable (coming from the rotor to the rear brake jaws) and pre-

set the rear jaw fixing the cable tension with the jaw cable clip.

Assemble the upper cable (from the rotor to the rear cable lever)

Set the two fixed lower cables on the rotor's mobile flange using setting screws

screwed to the fixed flange. These two cables should be synchronised and the

flange should move in parallel to the fixed flange

To the same for the upper cables.

The mobile flange stroke should be maximum to enable the brake lever to provide

the system with maximum efficiency

Steering nut

Upper fixed flange

Mobile flange

upper adjustment

Steering cone

Steering

Fixed lower flange

2/U-type brake

Loosen triangle nut, bring this triangle to about 1cm above the safety hook then

tighten the jaw cable clip. Pull the cable, the two pads will then touch of rim.

Tighten the cable clip.

Squeeze the brake handle to check, and adjust the two arms between them tur-

ning the central setting nut.

Assembly of pegs

TO BRAKE

LEVER

upper cables

upper flange

screw

stroke

PARALLEL

mobile flange

lower flange

Lower adjustment screw

GUARANTEE CHARTER

The guarantee covers: all material or manufacturing fault observed by Decathlon

workshops, the replacement of defective parts by similar ones as well as labour.

Guarantee period:

• Five years for the frame

• Two years for other components, paint and labour

Coverage of the guarantee

• Absence of shocks, the product should not be damaged in normal conditions

of use

• The product should be used in compliance with instructions and regularly main-

tained by our workshops

• Original parts were not replaced by non-approved parts

Exclusion from the guarantee

• Damage the responsibility of a third party or the result of an intentional fault

• Damage resulting from maintenance or use not compliant with the manufacture-

r's instructions or negligence

• Wear parts (bulbs, cables and housing, toe clips, plates, chain, rim, spindles...)

and their replacement

• Any product that has been modified outside our workshops

• Original parts replaced by non-approved parts

• Damage the result of fire, lightning, storm, vandalism or non-secure transport