Decathlon City 500 매뉴얼 및 보증 지침 - 페이지 11
{카테고리_이름} Decathlon City 500에 대한 매뉴얼 및 보증 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Decathlon City 500 17 페이지.
페이지 인쇄
3/ Always move the back of the pad away from the rim
Be careful to leave about 1 mm between the rim and
the pad.
Changing brake pads
Unscrew your pad with an Allen wrench until
he can be removed and carry out the reverse
operation when you change it.
Adjusting the brakes
The operation/ how to use the brake
When you brake, use only the back brake first and then use slightly and gradually
the front brake. An over load on the front brake lever may result in falling down
forward. Be sure you know how to use your brakes before riding the bike.
I/ Unscrew the pad fixings (see the essential tools section)
2/ Put the pads on the rim and adjust as described Be careful to tighten in the
pad fixing
3/ Adjust the balancing (positioning) of the callipers if necessary
Pads will be handled differently depending on the type of brake:
Aluminium tube
Side pull
CABLE
NUT
PULL THE CABLE
35 mm or more
More tension
screwdriver
Less tension
screwdriver
Tension spring
+ adjustment screw
CANTIVELER
TRIANGLE
SAFETY HOOK
POSITION
PULL THE CABLE
20
RIM
For disc brakes (see the manufacturer's manual)
1/ Assembling the brake cable
Loosen in the cable clip on the brake caliper
Remove the old cable from its housing
Slide the new cable into the housing, pass it through the hole in the brake caliper
housing block then put the cable into the cable clip.
Press the brake cam half down and close the cable clip.
Cut the excess cable
Adjust the setting using the brake lever setting key
2/Changing the friction pads
Loosen the brake cable
Remove the supporting screws from the caliper on the fork
Remove the screws that fix the friction pads or lift and pull the plate directly
depending on the model.
Remove the pads and replace them in the same way
Loosen the cam check nut, adjust the stroke using an Allen wrench then tighten the
nut.
Warning :
To maintain efficient breaking and limit wear in the rims, replace the pads as soon
as wear becomes too noticeable. A worn pad is one where the fluting or the not-
ches can no longer be seen...
The sides that run against the pads should also be watched As soon as signs of
the side opening or loss of parallelism, change your rim.
Disc brakes become hot and may cause burning, after breaking weight about 30
minutes before touching the rotor.
4/ Derailleur
You will find two types of the changer on Decathlon bicycles
- a conventional gear changer (most bicycles)
- speeds in the hub
TRIANGLE NU
CABLE
ADJUSTMENT
21