Airflow 90001002 설치 및 운영 지침 매뉴얼 - 페이지 9

{카테고리_이름} Airflow 90001002에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Airflow 90001002 16 페이지. External wall insulation vent kit

페이지 인쇄

NOTE

CAUTION

NOTE

Installation step EXTERNAL WALL:

NOTE

we reserve the right to make changes without prior notice

Uno hab Ext. Wall Ins. Vent Kit

Installation step INTERNAL WALL:

5 . Shorten wall installation sleeve.

6 . Position wall installation sleeve with EPP front wedge flush to the internal wall in the core drill hole and align

centrally with the empty conduit (Fig. 7).

NOTE: Note the strength of the plaster or wall covering!

m The wall installation sleeve must not be trimmed on the internal side of the wall!

7 . Position wall installation sleeve "inside" and "outside" with provided fixing wedges (Fig. 8).

m The fixing wedges must not deform the wall installation sleeve when inserted!

m A wall installation sleeve condensate drain gradient of 1°-2° outward must be maintained!

Wall installation sleeve

with EPP front wedge

for condensate drain

Empty

conduit

INTERNAL WALL

8 . Fill annular gap "inside" and "outside" with non-pressurised installation foam (Fig. 9/10).

9 . After a sufficient drying time, remove the protruding fixing wedges and excess installation foam.

If necessary, remove EPP material (lower front wedge) and any installation foam residue for cable entry (Fig. 9).

10 . Create diffusion-tight seal on annular gap (Fig. 10).

Installation

foam

m Cut out

long hole

INTERNAL WALL

11 . Place protective cover on the wall installation sleeve.

1. Remove protective cover.

2. Pull seal onto outside of wall installation sleeve (Fig.11) .

3. Shorten soffit channel to the desired length.

Note the installation requirements for the soffit channel! (see chapter 4.0 Installation overview soffit element)

Fixing wedge

Fig. 7

EPP front wedge

for condensate

drain

INTERNAL WALL

Fig. 9

Sealant

Annular

gap

INTERNAL WALL

Fig.11

Installation and Operating Instructions

Fig. 8

Fixing

wedge

Fig.10