Gamma 5003 소유자 매뉴얼 - 페이지 14

{카테고리_이름} Gamma 5003에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma 5003 19 페이지. 6 point mounting
Gamma 5003에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지)

페이지 인쇄

1. Tension Calibration

DISK BRAKE ADJUSTMENT

Adjusting the Tensioner Brake

Step 1

After stringing many racquets, the brake of the tensioner

may need to be adjusted. The Brake Adjustment Bolt

can be accessed through the hole in the face of the

tensioner cover, which does not need to be removed for

adjustment. The Tensioner Cover has been removed in

the pictures for illustration purposes.

A - Cover Screws

B - Lock Bolt

Step 2

With the brake lever engaged, loosen the lower hex bolt

located on the back side of the tensioner frame with the

10 mm box wrench. Note: The hex bolt should only be

loosened until loose enough to turned by hand and must

not be removed completely.

C - Brake Adjustment Bolt

Step 3

With the hex bolt loosened and the brake lever engaged

in the latch, insert the 6 mm hex wrench into the set

screw locted inside the nut located at the base of the

brake lever. To tighten the braking mechanism, turn the

set screw counter clockwise by about 1/8 turn. Re-

tighten the hex bolt on the back side of the tensioner

frame and check for brake tightness. The tensioner

should move freely along the track with the brake lever

engaged and should hold tension with the brake lever

released. If more adjustment is needed, repeat steps

above until properly adjusted.