Gamma 7000 Es 소유자 매뉴얼 - 페이지 16

{카테고리_이름} Gamma 7000 Es에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma 7000 Es 20 페이지.

페이지 인쇄

MAINTENANCE and ADJUSTMENTS

8 8 . 8

High KGs

High LBs

from the L.E.D. display cover plate cover. Rotate screw ("L") in small increments until the

displayed tension matches the tension indicated on the calibrator. Set the machine tension

to 80 lbs. and apply tension to the calibrator. If the measured tension is innacurate, rotate

screw ("H") in small increments until the displayed tension matches the tension indicated on

the calibrator. Since adjustment of the "L" screw at 20 lbs can influence the tension at 80 lbs

and visa versa, repeat these steps until the set tension matchs the tension reading of the

calibrator at both 20 and 80 lbs. Replace the 2 caps in the L.E.D. display cover plate.

Please note that there will be a range of tension from the maximum tension at which the

tensioner stops pulling (high end of the range), to the minimum tension at which the tensioner

starts pulling again (low end of the range). This difference between the high and low end of

the range can vary from 2-4 lbs depending on the string used to calibrate the machine and

the speed of the tensioner. For consistency, we recommend that the tension setting of the

machine be calibrated as close as possible to the high end of the range, using the fast pulling

speed and a synthetic string, which is the method used at the factory. Using this method will

be the most consistent and will also insure that the racquet will not be over tensioned.

direction. If the clamp leaves impressions or damages the string, it may be excessively tight

and should be adjusted by turning the hex screw counter clockwise to open the gap between

the jaws. The clamp jaws should be cleaned periodically to be free from dirt, oil, and any string

coating for them to grip properly.

Note: The string clamps supplied with your Gamma stringing machine can accomodate tight

string patterns such as badminton. Depending on the string pattern, the clamp may spread the

strings slightly which will not compromise the quality of the string job.

Low KGs

Low LBs

Selection

Switch

LBs

KGs

Adjustment

Knob

Tension Calibration Procedure

If you suspect that your 7000Es is not pulling the

correct tension, you should check the tension

with a Gamma Tension Calibrator which provides

a measurement of the actual pulling tension

being applied by the machine.

With the machine set for the fast pulling speed,

and the tension set at 20 lbs., place one end of a

calibrator equipped with synthetic string into a

string clamp. Place the opposite end into the

string gripper and apply tension. If the measured

tension is inaccurate, remove the 2 small caps

Adjusting the String Clamps

The clamps provided with your stringing

machine will need minor adjustments ac-

cording to what string type, construction,

and gauge you are using.

To adjust the gap (clamping pressure) be-

tween the clamp jaws, insert the string

through the racquet as if you were beginning

the main strings. Clamp the strings and pull

tension. If the string slips through the jaws of

the clamp, tighten the clamp by turning the

Adjustment Knob, located on the fixed clamp

jaw opposite of the handle, in the clockwise